19mm Rubber Hose (30m)

19mm Rubber Hose (30m) for Fire Hose Reel Systems

The 19mm Rubber Hose (30m) provides a flexible water-delivery route between a compatible fire hose reel assembly and its outlet component. Its nominal hose size is 19 mm and its stated hose length is 30 m. These two user-supplied dimensions help identify the required product, while internal diameter tolerances, outside diameter, wall construction and all performance values must be confirmed against the final manufacturer data.

Coordinate supply through AJ Safety Solutions, review the related fire hose product category, and match the hose with approved hose reel equipment for the intended installation.

Flexible Water-Delivery Component

A hose reel hose must wind onto the compatible drum, route through the intended guide arrangement and connect to the specified inlet and outlet fittings. The rubber hose body provides the continuous water passage, but its reinforcement, cover texture, lining, bend behaviour and end preparation depend on the selected model. Installation should avoid twists, sharp contact points and routing that restricts normal deployment or rewinding.

Key Product Considerations

• Nominal 19 mm identification supports comparison with the project hose schedule.
• Stated 30 m length supports layout and reach review for the intended fire point.
• Flexible coiled form is suited to integration with a compatible hose reel assembly.
• Accessible hose surfaces support visual checks during planned maintenance.

Typical Applications

This hose may be considered for indoor or otherwise suitably protected fire hose reel installations in commercial buildings, industrial facilities, warehouses and service areas when the complete approved design calls for the stated size and length. Suitability for any outdoor, exposed or special environment must be confirmed separately.

Specification and Ordering Notes

Confirm hose construction, reinforcement, cover and lining materials, working pressure, test pressure, burst characteristics, bend radius, temperature limits, colour, connection type, coupling size, approval, marking and supplied accessories before purchase. No unverified value, certification or included end fitting is asserted in this generic record.

Inspection and Standards Context

Inspect the hose for cuts, abrasion, cracking, flattening, leakage, damaged ends and routing obstructions in accordance with the approved maintenance programme. Project teams may consult NFPA 14 for relevant standpipe and hose system requirements and NFPA 25 for inspection, testing and maintenance guidance. Adopted codes, approved drawings, manufacturer instructions and the authority having jurisdiction remain controlling.